When opening the device, choose the wireless mode, remove the sensor’s gasket, and then put the sensor into the water.so the device can connect with the sensor.
Use transducer connects with the device, put the transducer into the water, the underwater information will be shown on screen.
The wireless sensor is more suitable for remote control, it has a long distance wireless operating range. the wired sensor is more suitable for sea, it can detect deeply than wired sensor.
Ensure there’s no water into sensor.
Check the receiving distance is out of the range.
Check if it has connected with the correct wifi, then ensure the fish finder and sensor have enough power.
Check the partial zoom function, and adjust the normal value.
Check if the gasket has been removed.
Check if the device has chosen the wireless mode.
Check if it is connected to the sensor’s wifi.
Check if the shallow water alarm is turned on and there is a shallow water area.
Check if there is a reef at the bottom of the water.
Check if it has connected with the correct wifi, then ensure the fish finder and sensor have enough power.
In the rough water surface, the metal detector of the sensor will be off the water surface, which will affect the stability. We recommend that it’s better to use a wired model.
In the rough water surface, the metal detector of the sensor will be off the water surface, which will affect the stability. We recommend that it’s better to use a wired model.
Because in winter the temperature is extreme difference, so the screen will be easy to fog.
It is possible that the screen is flooded,so use a hair dryer to dry the water vapor in the screen.
Because the fish finder has a probing angle, the fish is just at a shallow water position not in the detection range.
